Inleiding

You will remove the back cover, remove screws from the fan and heat sink, and take out the fan from the laptop.

Onderdelen

Geen onderdelen nodig.

Place the laptop so the back cover is facing up.
  • Place the laptop so the back cover is facing up.

Voeg opmerking toe

Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
  • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

Voeg opmerking toe

  • Lift off the cover.

Voeg opmerking toe

  • Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.

  • Pull the plastic part of the cable, not the wires, so that the plug does not break.

Voeg opmerking toe

  • Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.

Voeg opmerking toe

  • The fan is permanently attached to the silver heat sink next to the RAM.

  • To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.

  • Take out the screws in the numerical order shown on the heat sink.

Voeg opmerking toe

  • Pull the fan and heat sink toward you at a 20 degree angle upward.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Toni Pipes

Lid sinds: 05-10-10

297 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 21-31, Regan Fall 2010 Lid van Cal Poly, Team 21-31, Regan Fall 2010

CPSU-REGAN-F10S21G31

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 4

Altijd: 4,694