Use a plastic spudger tool to remove the plastic frame.
  • Use a plastic spudger tool to remove the plastic frame.

  • Insert the tool into the groove in the center of the top of the outer frame and lever it gently until it pops out.

Voeg opmerking toe

Use a phillips head screw driver to remove all four screws in the corners around the screen.
  • Use a phillips head screw driver to remove all four screws in the corners around the screen.

  • Set the screws aside for later.

Voeg opmerking toe

  • Gently pull from both ends to separate the front panel from the back.

  • Do not force the pieces apart wider than the length of the connecting wires or you will damage the wiring.

Voeg opmerking toe

  • Locate the white wire clip. Gently unplug it using either your fingers or tweezers.

Voeg opmerking toe

  • Carefully expose both halves of the device.

  • Be sure to not pull the two halves apart too hard to avoid damaging the black wire.

Voeg opmerking toe

Conclusie

Your device should be ready to use once more.

2 andere personen hebben deze handleiding voltooid.

Adrian Leon

Lid sinds: 07-10-10

169 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 22-1, Maness Fall 2010 Lid van Cal Poly, Team 22-1, Maness Fall 2010

CPSU-MANESS-F10S22G1

3 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 1

Altijd: 1,776