Inleiding

Removing the logic board from the Garmin Nuvi 200

Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

Voeg opmerking toe

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

Voeg opmerking toe

  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

Voeg opmerking toe

  • Peel away the tape holding the ribbon cable in place.

  • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

Voeg opmerking toe

  • Pull out the cable between the logic board and the speaker to disconnect them.

Voeg opmerking toe

  • Remove the three screws from the logic board using the #00 Phillips screwdriver.

  • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

Voeg opmerking toe

  • Detach the logic board form the battery by pulling out the cable.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Anjelica

Lid sinds: 11-04-10

504 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 25-90, Amido Spring 2010 Lid van Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 12

Altijd: 9,573