GameSir X2 Type-C Back Cover Replacement

Inleiding

If you need to open or replace the back cover of the GameSir X2 Type-C, use this guide. This guide provides access to the left joystick and trigger assembly. This guide is a pre-requisite for most replacements inside the housing of the device.

Wat je nodig hebt

Stap 1 Back Cover

GameSir X2 Type-C Back Cover Replacement, Back Cover: stap 1, afbeelding 1 van 2

GameSir X2 Type-C Back Cover Replacement, Back Cover: stap 1, afbeelding 2 van 2

Turn the device so the back faces you.

Vertaal

Stap 2

Remove the eight 6 mm T6 Torx screws.

Vertaal

Stap 3

Use a straight edge to remove the rubber pad on the front of the device.

Vertaal

Stap 4

Remove the four 4.5 mm screws with a Phillips #000 screwdriver.

Vertaal

Stap 5

Use a straight edge to pry open the controller, following the seam on the controller.
Some force is necessary, but be careful not to damage any of the clips holding the controller together.

Vertaal