1. Remove the batteries from the camera to prevent danger of electric shock.
    • Remove the batteries from the camera to prevent danger of electric shock.

    Voeg opmerking toe

  2. Locate all five screws on the camera. Then proceed to remove all the screws.
    • Locate all five screws on the camera. Then proceed to remove all the screws.

    Voeg opmerking toe

    • Beware, if your screwdriver does not fit properly, you may damage the screws' heads.

    • If your screwdriver does not fit, or you do not have the proper one, you can use a hot glue gun to fix the screwdriver to the head of the screw. Wait for it to harden slightly, and then try to remove the screws.

    Voeg opmerking toe

    • Remove outer case. Pull the back away from the main body of the camera.

    Voeg opmerking toe

    • Locate the LCD screen and anchoring screw.

    • Remove screw.

    Voeg opmerking toe

    • Carefully pull the LCD screen away from the board it is connected to.

    Voeg opmerking toe

    • Push both blue switches away from the holding device to unleach lcd ribbon.

    • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

    Voeg opmerking toe

    • Carefully detach the ribbon from where it was connected by the blue pins.

    Voeg opmerking toe

    • Now that everything has been disconnected from the board, remove LCD screen.

    Voeg opmerking toe

    • Remove the two screws holding the circuit board down.

    Voeg opmerking toe

    • Remove black sticky tape from circuit board and camera case.

    Voeg opmerking toe

    • Gently pull the circuit board away from the front side of the camera.

    • Be careful when removing assembly as to not break any solder leads or damage lens assembly.

    Voeg opmerking toe

    • Remove the logic board by pulling straight away from assembly.

    Voeg opmerking toe

    • Locate the flash unit of the camera. It includes the camera's flash and a capacitor.

    Voeg opmerking toe

    • Unsolder the flash unit at it's three points.

    • Be careful not to damage the circuit board or surrounding parts with the solder iron.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Cody

Lid sinds: 18-04-10

47 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 7-11, Maness Spring 2010 Lid van Cal Poly, Team 7-11, Maness Spring 2010

CPSU-MANESS-S10S7G11

3 Leden

4 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 3,628