Inleiding

Over time, the hose on your steel floor drive pump may wear or puncture. Use this guide to install a new hose.

  1. Use a pair of pliers to loosen the hose pinch by turning it counterclockwise a couple of turns.
    • Use a pair of pliers to loosen the hose pinch by turning it counterclockwise a couple of turns.

    • Continue to loosen the hose pinch by hand until it comes free from its threads.

    • Slide the hose pinch down the tube so that it does not interfere with removing the hose.

    Voeg opmerking toe

  2. Using a hobby knife, carefully slice a slit in the bottom of the hose to allow it to slide off.
    • Using a hobby knife, carefully slice a slit in the bottom of the hose to allow it to slide off.

      • Be careful and go slowly so as not to damage the nipple underneath.

    • Use a metal prying tool or flathead screwdriver to pry the hose up off of the nipple.

    • Remove the hose from the pump.

    Voeg opmerking toe

    • Slide the hose pinch off of the end of the old hose and onto the new hose.

    • Be sure that the threaded end of the hose pinch faces toward the open end of the new hose.

    Voeg opmerking toe

    • Use a metal rod or screwdriver to widen the new hose so that it will fit over the nipple.

    • Slide the hose in place.

    • Push down on the hose clamp while twisting it clockwise to thread it in place.

    Voeg opmerking toe

Eindstreep

iRobot

Lid sinds: 24-09-09

1 Reputatie

621 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 10

Altijd: 762