Ga door naar hoofdinhoud

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

Fairphone 1 Motherboard Assembly Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. Fairphone 1 Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 1 van 3 Fairphone 1 Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 2 van 3 Fairphone 1 Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 3 van 3
    • Use tweezers to remove the volume rocker and power buttons from the display assembly.

    • During reassembly make sure the orientation of the buttons is correct. The rubber backings must fit into the channels in the assembly.

  2. Fairphone 1 Motherboard Assembly Replacement: stap 2, afbeelding 1 van 1
    • Use the flat end of a spudger to disconnect the antenna cable connector.

    • Make sure to only disconnect the connector from its socket, and not the entire socket from the board.

  3. Fairphone 1 Motherboard Assembly Replacement: stap 3, afbeelding 1 van 2 Fairphone 1 Motherboard Assembly Replacement: stap 3, afbeelding 2 van 2
    • Use tweezers to remove the adhesive foam tape from the top of the digitizer cable ZIF socket.

  4. Fairphone 1 Motherboard Assembly Replacement: stap 4, afbeelding 1 van 3 Fairphone 1 Motherboard Assembly Replacement: stap 4, afbeelding 2 van 3 Fairphone 1 Motherboard Assembly Replacement: stap 4, afbeelding 3 van 3
    • Use the tip of a spudger to flip open the tab on the digitizer ZIF connector.

    • Use tweezers to pull the digitizer cable away from its socket on the motherboard.

  5. Fairphone 1 Motherboard Assembly Replacement: stap 5, afbeelding 1 van 1
    • Remove the three 2.5 mm Phillips #000 screws securing the motherboard to the display assembly.

  6. Fairphone 1 Motherboard Assembly Replacement: stap 6, afbeelding 1 van 2 Fairphone 1 Motherboard Assembly Replacement: stap 6, afbeelding 2 van 2
    • Do not try to remove the motherboard just yet, as it is still connected to the display assembly by the display data cable.

    • Gently lift the top end of the motherboard up to expose the display data cable.

    • The rear-facing camera may be adhered to the display assembly. Try to pry it and the motherboard up together.

  7. Fairphone 1 Motherboard Assembly Replacement: stap 7, afbeelding 1 van 2 Fairphone 1 Motherboard Assembly Replacement: stap 7, afbeelding 2 van 2
    • Use the tip of a spudger to disconnect the display data cable from the back of the motherboard.

  8. Fairphone 1 Motherboard Assembly Replacement: stap 8, afbeelding 1 van 1
    • Remove the motherboard from the display assembly.

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Andrew Optimus Goldheart

Lid sinds: 10/17/09

502.332 Reputatie

407 handleidingen geschreven

Team

iFixit Lid van iFixit

Staff

136 Leden

16.573 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 2,366