Etekcity Lasergrip 1080 Laser Replacement

Inleiding

This will teach you to uninstall and reinstall a laser from the motherboard. This is needed if the laser stops working and cannot be turned on by pressing the button to do so. The tools required will be a screwdriver and a soldering iron. The soldering iron is hot and may cause a potential hazard. For those who are uncomfortable soldering, there is a link to a soldering guide in the Troubleshooting section of the device page.

Wat je nodig hebt

Stap 1 Battery

Etekcity Lasergrip 1080 Laser Replacement, Battery: stap 1, afbeelding 1 van 1

Pull the battery cover away from the handle by gripping near the thumb groove.

Vertaal

Stap 2

Gently pull the battery out of the handle.
Excessive force could damage wires.

Vertaal

Stap 3

Disconnect the battery by pulling the connector away from it.
Positive first
Negative second
When replacing the battery, this order is reversed.

Vertaal

Stap 4 Buttons

Etekcity Lasergrip 1080 Laser Replacement, Buttons: stap 4, afbeelding 1 van 2

Etekcity Lasergrip 1080 Laser Replacement, Buttons: stap 4, afbeelding 2 van 2

Remove the battery cover from the device by pulling it straight out.

Vertaal

Stap 5

Using the plastic opening tool remove the front and rear yellow covers.
When removing the back cover, be careful not to lose the buttons as they are not connected.

Vertaal

Stap 6

Remove the two 3.1 mm Phillips #0 screws.

Vertaal

Stap 7

Pull the two halves apart.
Be careful not to lose any components on the inside.

Vertaal

Stap 8

Realign the buttons with the button terminals.
Red terminal to red button.
Orange terminal to orange button.
Yellow terminal to yellow button.

Vertaal

Stap 9 Etekcity Lasergrip 1080 Trigger Replacement

Etekcity Lasergrip 1080 Laser Replacement, Etekcity Lasergrip 1080 Trigger Replacement: stap 9, afbeelding 1 van 2

Etekcity Lasergrip 1080 Laser Replacement, Etekcity Lasergrip 1080 Trigger Replacement: stap 9, afbeelding 2 van 2

Carefully pull the trigger out.
The trigger is spring loaded, so be careful that you do not lose the spring as you pull the trigger out.
To put the trigger back in, align the peg with the hole in the handle and align the shaft with the button terminal.

Vertaal

Stap 10 Laser

Etekcity Lasergrip 1080 Laser Replacement, Laser: stap 10, afbeelding 1 van 1

Pull the motherboard out of its slot in the device.

Vertaal

Stap 11

Use a soldering iron to melt the solder that holds the wires for the laser to the motherboard.
Soldering irons are hot and should only be handled by those who know what they are doing and are wearing proper safety equipment. There is a link to a soldering guide in the Troubleshooting section of the device page.

Vertaal