Repareer je spullen Gemeenschap Winkel

Ematic Genesis 2 Charging Port Replacement

Inleiding

This repair guide will teach you how to replace the charging port in the Ematic Genesis 2 tablet.

Wat je nodig hebt

  1. Ematic Genesis 2 Charging Port Replacement, Charging Port: stap 1, afbeelding 1 van 2 Ematic Genesis 2 Charging Port Replacement, Charging Port: stap 1, afbeelding 2 van 2

    • With your fingers, carefully pry off the back plastic casing. Starting at the corners is usually the easiest.

    Bewerken

  2. Ematic Genesis 2 Charging Port Replacement: stap 2, afbeelding 1 van 3 Ematic Genesis 2 Charging Port Replacement: stap 2, afbeelding 2 van 3 Ematic Genesis 2 Charging Port Replacement: stap 2, afbeelding 3 van 3

    • Remove all four screws surrounding the battery with the Phillips head screwdriver.

    • Carefully remove the battery from the device using the Metal Spudger tool to gently separate the battery by wedging it between the device and the battery.

    Bewerken

  4. Ematic Genesis 2 Charging Port Replacement: stap 3, afbeelding 1 van 2 Ematic Genesis 2 Charging Port Replacement: stap 3, afbeelding 2 van 2

    • Remove both screws on either side of the audio jack using the Philips head screwdriver.

    • Detach audio jack from device.

    Bewerken

  5. Ematic Genesis 2 Charging Port Replacement: stap 4, afbeelding 1 van 2 Ematic Genesis 2 Charging Port Replacement: stap 4, afbeelding 2 van 2

    • Remove the 3 screws surrounding the circuit board using the Philips head screwdriver.

    • Carefully disconnect the circuit board from the device by detaching the copper flexible PCB ribbon cable.

    Bewerken

  6. Ematic Genesis 2 Charging Port Replacement: stap 5, afbeelding 1 van 2 Ematic Genesis 2 Charging Port Replacement: stap 5, afbeelding 2 van 2

    • Use a soldering iron to heat the solder holding the charging port to the circuit board.

    • Remove the charging port from board using tweezers.

    Bewerken

  7. Ematic Genesis 2 Charging Port Replacement: stap 6, afbeelding 1 van 1

    • Solder replacement port into place.

    • Make sure all connections match original.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 543