Repareer je spullen Gemeenschap Winkel

Ecovacs Deebot 900 Front Bumper Replacement

Inleiding

The front bumper of the Ecovacs Deebot 900 is used to sense obstacles in its path. A malfunctioning front bumper can cause the Deebot to move in a circular fashion. Use this guide to remove or replace the front bumper on your Ecovacs 900 Deebot.

Wat je nodig hebt

  1. Ecovacs Deebot 900 Front Bumper Replacement, Battery: stap 1, afbeelding 1 van 1

    • Remove all the brushes from the Deebot.

    Bewerken

  2. Ecovacs Deebot 900 Front Bumper Replacement: stap 2, afbeelding 1 van 1

    • Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

    Bewerken

  3. Ecovacs Deebot 900 Front Bumper Replacement: stap 3, afbeelding 1 van 1

    • Remove the battery cover.

    Bewerken

  5. Ecovacs Deebot 900 Front Bumper Replacement: stap 4, afbeelding 1 van 1

    • Using the two white straps on the sides of the battery, gently remove the battery. ​

    • Be careful not to rip out the battery cable.

    Bewerken

  6. Ecovacs Deebot 900 Front Bumper Replacement: stap 5, afbeelding 1 van 1

    • Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

    Bewerken

  7. Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: stap 6, afbeelding 1 van 2 Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: stap 6, afbeelding 2 van 2

    • Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    Bewerken

  8. Ecovacs Deebot 900 Front Bumper Replacement: stap 7, afbeelding 1 van 1

    • Remove the black strip on the bottom of the bumper.

    Bewerken

  9. Ecovacs Deebot 900 Front Bumper Replacement: stap 8, afbeelding 1 van 2 Ecovacs Deebot 900 Front Bumper Replacement: stap 8, afbeelding 2 van 2

    • Carefully lift up the bumper untill it pops out of place.​

    Bewerken

  10. Ecovacs Deebot 900 Front Bumper Replacement: stap 9, afbeelding 1 van 2 Ecovacs Deebot 900 Front Bumper Replacement: stap 9, afbeelding 2 van 2

    • Disconnect the two cables connecting the bumper to the body of the Deebot.

    • Remove the front bumper from the device.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Één opmerking

Where may I buy the front bumper assembly? I'm trying to replace one for a deebot 901 but the mfg tells me they don't see the part directly.

Chris Khacherian - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 38

Afgelopen 30 dagen: 214

Altijd: 9,680