Ga door naar hoofdinhoud

Inleiding

Often, through expected usage, an analog stick may become dislodged or misaligned on the DualShock 2 Wireless controller. This guide will show how to remove the faulty stick and realign it.

Onderdelen

Geen onderdelen opgegeven.

  1. DualShock 2 Wireless Controller Analog Stick Replacement, Analog Stick: stap 1, afbeelding 1 van 2 DualShock 2 Wireless Controller Analog Stick Replacement, Analog Stick: stap 1, afbeelding 2 van 2
    • Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver.

  2. DualShock 2 Wireless Controller Analog Stick Replacement: stap 2, afbeelding 1 van 2 DualShock 2 Wireless Controller Analog Stick Replacement: stap 2, afbeelding 2 van 2
    • Pull apart the outer casing by hand, or by using a plastic opening tool, from the bottom of the controller.

    • Be mindful not to sever the connection between the battery pack attached to the back casing and the internal board

  3. DualShock 2 Wireless Controller Analog Stick Replacement: stap 3, afbeelding 1 van 2 DualShock 2 Wireless Controller Analog Stick Replacement: stap 3, afbeelding 2 van 2
    • Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together.

  4. DualShock 2 Wireless Controller Analog Stick Replacement: stap 4, afbeelding 1 van 2 DualShock 2 Wireless Controller Analog Stick Replacement: stap 4, afbeelding 2 van 2
    • Lift the analog stick board away from the front of the controller.

    • Remove the detached or loose analog stick for realignment.

  5. DualShock 2 Wireless Controller Analog Stick Replacement: stap 5, afbeelding 1 van 1
    • Realign the analog stick by pushing the removed stick back into its chassis with focus on pushing it in at the new, desired resting angle. You should feel or hear a small click if done correctly.

    • The stick may not immediately click into place under the pressure. Instead of pushing harder, try rotating the stick 90 degrees and pushing down again.

Conclusie

To reassemble your device, follow these instructions in reverse order.

11 andere personen hebben deze handleiding voltooid.

Roger Campbell

Lid sinds: 12-07-17

237 Reputatie

1 Handleiding geschreven

Team

Texas Tech, Team S1-G1, Rauch Summer 2017 Lid van Texas Tech, Team S1-G1, Rauch Summer 2017

TTU-RAUCH-SU17S1G1

2 Leden

2 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 7

Afgelopen 7 dagen: 59

Afgelopen 30 dagen: 263

Altijd: 7,717