Ga door naar hoofdinhoud

Disassembling the Garmin eTrex Vista-H Outer Case

Wat je nodig hebt

  1. Disassembling the Garmin eTrex Vista-H Outer Case, Removing Battery: stap 1, afbeelding 1 van 1
    • Flip the device to the backside, and locate the metal tab at the center of the back cover.

  2. Disassembling the Garmin eTrex Vista-H Outer Case: stap 2, afbeelding 1 van 1
    • Lift the metal tab up, and rotate it counterclockwise. This will unlock the back case cover.

  3. Disassembling the Garmin eTrex Vista-H Outer Case: stap 3, afbeelding 1 van 2 Disassembling the Garmin eTrex Vista-H Outer Case: stap 3, afbeelding 2 van 2
    • Lift the battery plate off to either insert or remove 2 AA batteries.

  4. Disassembling the Garmin eTrex Vista-H Outer Case, Disassembling the Garmin eTrex Vista-H Outer Case: stap 4, afbeelding 1 van 2 Disassembling the Garmin eTrex Vista-H Outer Case, Disassembling the Garmin eTrex Vista-H Outer Case: stap 4, afbeelding 2 van 2
    • With the wedge side of a spudger (or a small, flat head screwdriver), remove the black rubber case support from the device body.

  5. Disassembling the Garmin eTrex Vista-H Outer Case: stap 5, afbeelding 1 van 3 Disassembling the Garmin eTrex Vista-H Outer Case: stap 5, afbeelding 2 van 3 Disassembling the Garmin eTrex Vista-H Outer Case: stap 5, afbeelding 3 van 3
    • With the pick side of a spudger (or tweezers), peel the sticky tape from the device.

  6. Disassembling the Garmin eTrex Vista-H Outer Case: stap 6, afbeelding 1 van 1
    • Split the front and rear panels by inserting a small pointed tool (such as a pen point or a screwdriver tip SL1.5) in the 5 plastic tabs along the sides of the device.

    • Do not remove the back panels quickly. If too much force is applied, there is a wire connection that will break.

    • CAUTION! Be careful not to force the tabs inward. This will result in broken tabs.

  7. Disassembling the Garmin eTrex Vista-H Outer Case: stap 7, afbeelding 1 van 2 Disassembling the Garmin eTrex Vista-H Outer Case: stap 7, afbeelding 2 van 2
    • With tweezers (or your fingernails), carefully disconnect the wires between the PC input and the motherboard.

Conclusie

To reassemble your device, follow these instructions in reverse order.

7 andere personen hebben deze handleiding voltooid.

Ryan Green

Lid sinds: 10/17/10

93 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 21-30, Regan Fall 2010 Lid van Cal Poly, Team 21-30, Regan Fall 2010

CPSU-REGAN-F10S21G30

3 Leden

5 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 3

Altijd: 4,982