Onderdelen

Geen onderdelen nodig.

  1. Using the Phillips #0 in the bit driver, carefully loosen and remove the single  5mm screw.
    • Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.

    • With the retaining screw removed, lift the panel upwards to separate it from the netbook.

    Voeg opmerking toe

  2. To replace the panel, do step 1 in reverse:
    • To replace the panel, do step 1 in reverse:

      • Align the panel slots in the appropriate grooves and set in place.

      • With the bit driver, replace the screw to secure the RAM panel.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Using the bit driver and the Phillips bit, remove both of the panel's retaining screws.

    • With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.

    • The hard drive is located beneath this cover and is now accessible.

    Voeg opmerking toe

    • To replace the hard drive panel, do step 3 in reverse:

      • Place the panel back in its original position and press down.

      • If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.

      • With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

Lid sinds: 18-10-13

943 Reputatie

9 handleidingen geschreven

Team

Clemson, Team 14-2, Benson Fall 2013 Lid van Clemson, Team 14-2, Benson Fall 2013

CLEM-BENSON-F13S14G2

3 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 7

Altijd: 598