Ga door naar hoofdinhoud

Disassembling Sony Clie PEG-SL10

Wat je nodig hebt

  1. Disassembling Sony Clie PEG-SL10, Disassembling Sony Clie PEG-SL10: stap 1, afbeelding 1 van 1
    • Start by holding your Sony Clie PEG-SL10 face-up in your hand.

  2. Disassembling Sony Clie PEG-SL10: stap 2, afbeelding 1 van 1
    • Turn over your Sony Clie and unlock the cover slide lock.

  3. Disassembling Sony Clie PEG-SL10: stap 3, afbeelding 1 van 1
    • After unlocking the cover slide lock, remove the cover and set aside.

  4. Disassembling Sony Clie PEG-SL10: stap 4, afbeelding 1 van 1
    • Turn your Sony Clie face-up.

    • Using a Phillips #0 screwdriver, remove the six case screws on the sides and bottom of the device.

  5. Disassembling Sony Clie PEG-SL10: stap 5, afbeelding 1 van 1
    • Remove the front case by gently lifting away from the device.

  6. Disassembling Sony Clie PEG-SL10: stap 6, afbeelding 1 van 1
    • Turn the Sony Clie face down and open the back case by prying open the left side of the device.

    • It will open like a book connected by hinges on the right side.

  7. Disassembling Sony Clie PEG-SL10: stap 7, afbeelding 1 van 1
    • Gently pry off the right side off the back panel and set it aside, leaving room for the scroll wheel at the upper right corner.

  8. Disassembling Sony Clie PEG-SL10: stap 8, afbeelding 1 van 1
    • Using a Phillips #0 screwdriver, remove the two screws holding the scroll wheel in place.

  9. Disassembling Sony Clie PEG-SL10: stap 9, afbeelding 1 van 1
    • Pull out both sides of the clip to remove the scroll wheel power cable from the device.

  10. Disassembling Sony Clie PEG-SL10: stap 10, afbeelding 1 van 1
    • Using a Phillips #0 screwdriver, unscrew the two screws towards the bottom sides of the Sony Clie to remove the battery harness.

  11. Disassembling Sony Clie PEG-SL10: stap 11, afbeelding 1 van 1
    • Pull the power cable from the socket located above the upper right side of the battery harness.

  12. Disassembling Sony Clie PEG-SL10: stap 12, afbeelding 1 van 1
    • Gently pull out the clips to remove the bottom power cables from the motherboard after removing the battery harness.

  13. Disassembling Sony Clie PEG-SL10: stap 13, afbeelding 1 van 1
    • Rotate the motherboard 180 degrees so that it is upside down facing toward you to expose the power cables on the other side.

  14. Disassembling Sony Clie PEG-SL10: stap 14, afbeelding 1 van 1
    • Gently pull out the clips to remove the top power cables from the motherboard.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Bijgevoegde documenten

Steve

Lid sinds: 10/18/11

9 Reputatie

1 Handleiding geschreven

Team

James Madison, Team 1-4, Allen Fall 2011 Lid van James Madison, Team 1-4, Allen Fall 2011

JMU-ALLEN-F11S1G4

3 Leden

4 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 12

Altijd: 1,693