Inleiding

This guide will instruct you to take the left cover off of the camcorder.

Remove the 6-7.9mm ph#0 screws on the back and bottom. Remove the one 3.8mm ph#0 screw on the bottom.
  • Remove the 6-7.9mm ph#0 screws on the back and bottom.

  • Remove the one 3.8mm ph#0 screw on the bottom.

  • Remove the two 7.5mm ph#0 screws on the back and bottom.

Voeg opmerking toe

Remove 5.8mm ph#1 screw from the side button panel. Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.
  • Remove 5.8mm ph#1 screw from the side button panel.

  • Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.

Voeg opmerking toe

Pry along the seam on the top side near the buttons with a spudger. Pry along the seam on the top side near the buttons with a spudger.
  • Pry along the seam on the top side near the buttons with a spudger.

Voeg opmerking toe

Pull the left panel away from the rest of the camcorder. Unplug the red speaker cable located at the rear of the device.
  • Pull the left panel away from the rest of the camcorder.

  • Unplug the red speaker cable located at the rear of the device.

  • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Ashley Katchadourian

Lid sinds: 20-01-11

112 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 5-20, Amido Winter 2011 Lid van Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 583