Inleiding

It is the first step in repairing the internal components of the cube.

Onderdelen

Geen onderdelen nodig.

  1. Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.
    • Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.

    • Push back the handle after you have taken the core out of the case.

    Voeg opmerking toe

  2. Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.
    • Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.

    Voeg opmerking toe

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Slowly lift the plate off the cube and disconnect the power cord.

    Voeg opmerking toe

    • Remove the four pillars from each corner.

    • The pillars should come out fairly easily.

    If the Cube has an Airport card installed, it must be removed. This can be accomplished by disconnecting its antenna, and pulling gently on the clear plastic tab on its end. The bracket it is contained in must be unlatched from the frame and rotated out of the way to get to the two optical drive mounting screws beneath it.

    olearydq - Antwoord

    There is a ribbed cooling plate attached to the hard drive that must be removed before step 7.

    isitism - Antwoord

    There is no need to remove the four pillars. Skip step 4. In step 5, don't turn the Cube on it's side. The Airport slot swings out like a door, providing access to the IDE ribbon and power cables to complete step 6. Complete steps 6 and 7 while the cube is upright.

    timhood - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order.

6 andere personen hebben deze handleiding voltooid.

Ryan Chun

Lid sinds: 24-06-10

674 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 2-7, Johann Summer 2010 Lid van Cal Poly, Team 2-7, Johann Summer 2010

CPSU-JOHANN-R10S2G7

5 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 10

Afgelopen 30 Dagen: 43

Altijd: 9,115