Inleiding

How to replace the spring loaded battery cover or the spring.

Onderdelen

Geen onderdelen nodig.

  1. Locate the battery cover on the bottom of the camera.
    • Locate the battery cover on the bottom of the camera.

  2. Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.
    • Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.

    • Remove the batteries from the camera.

    • Unscrew and remove four (3mm) screws on the right side of the camera. This will release the front and back casings.

    • Use your nail or a flat object to pry up the edge of the front casing. Push the casing up and back.

    • Repeat this step for the back casing.

    • Locate the black plastic strip under the screen above the white plastic strip.

    • Pull up both sides of the black piece up about a mm.

    • The black plastic piece is not meant to come all the way off, just enough to release the screen.

    • Once the piece is lifted carefully slide the screen out of the slot.

    • Unscrew the four (6mm) screws from the inner casing.

    • Pull the inner casing off.

    • If all the screws are out the casing will come off easily. If it doesn't check to make sure all the screws are completely out of the plastic.

    • Locate the push pin near the bottom of the camera.

    • Use the spudger to push the push-pin partly through.

    • From the other side pull the pin all the way out. The battery cover will fall off.

    • The spring can just be pulled out of the holes.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Dani

Lid sinds: 24-06-10

21 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 3-3, Johann Summer 2010 Lid van Cal Poly, Team 3-3, Johann Summer 2010

CPSU-JOHANN-R10S3G3

2 Leden

7 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,810