Inleiding

Since this is step one, you will just need to start with your camera.

Onderdelen

Geen onderdelen nodig.

Remove the battery and memory card from the device.
  • Remove the battery and memory card from the device.

Voeg opmerking toe

Remove 4 screws from the right side of the camera.
  • Remove 4 screws from the right side of the camera.

    • There are two 3.4mm screws at the top.

    • There are two 2.2mm screws at the bottom.

Voeg opmerking toe

  • Remove the single 3.4mm screw on the left side of the camera.

Voeg opmerking toe

  • Remove 5 screws from the base of the camera.

    • There are two 2.2mm screws next to the battery compartment.

    • There are three 4mm screws around the tripod mount.

Voeg opmerking toe

  • Slowly slide the back cover away from the device

    • The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

Voeg opmerking toe

  • Detach both ribbon cables using a spudger.

    • Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

Voeg opmerking toe

  • Remove the back casing from the camera.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Ben Canfield

Lid sinds: 10-10-10

403 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 9-21, Regan Fall 2010 Lid van Cal Poly, Team 9-21, Regan Fall 2010

CPSU-REGAN-F10S9G21

4 Leden

7 handleidingen geschreven

Één commentaar

That is not a disassembly! All is shows is taking the back of the camera off. How about showing how to disassembly the camera down to its individual components and make repairs, like getting the lens to extend of fixing a sticking shutter.

JR Tan - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 13

Altijd: 5,942