1. Remove the four rubber screw covers from encircled locations.
    • Remove the four rubber screw covers from encircled locations.

    • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

    • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

    Voeg opmerking toe

  2. Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
    • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

    • Be mindful of location and magnitude of applied force, so as not to damage the case.

    Voeg opmerking toe

    • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

    Voeg opmerking toe

    • Use fingernails to pry off minor LCD mount, as shown.

    • Remove the minor LCD

    Voeg opmerking toe

    • Unlock the LCD main board connectors shown in red boxes on the picture .

    • Use tweezers as necessary.

    Voeg opmerking toe

    • Place finger nails on the connector tab as shown.

    • Lift the connector tab up.

    Voeg opmerking toe

    • Pull/pivot the LCD main board as shown in order to remove.

    Voeg opmerking toe

    • Use a tweezers to lift up the main LCD

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Van

Lid sinds: 24-06-10

7 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 2-10, Johann Summer 2010 Lid van Cal Poly, Team 2-10, Johann Summer 2010

CPSU-JOHANN-R10S2G10

4 Leden

20 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,138