Inleiding

This guide is a step by step procedure to disassemble the base of the phone. It is the preliminary step in gaining access to the inner components of the Nokia 2366i.

Turn off the phone. Position the phone so that the back side is in view.
  • Turn off the phone.

  • Position the phone so that the back side is in view.

Voeg opmerking toe

Apply pressure on the cover while simultaneously sliding the cover downward.
  • Apply pressure on the cover while simultaneously sliding the cover downward.

  • Remove the back battery cover.

Voeg opmerking toe

Insert the spudger between the base of the phone and the phone battery. Position the phone so that the battery won't fall out of the phone. Carefully lift the battery out of the phone.
  • Insert the spudger between the base of the phone and the phone battery.

  • Position the phone so that the battery won't fall out of the phone.

  • Carefully lift the battery out of the phone.

    • The battery lifts out of the phone easily.

Voeg opmerking toe

Use a Phillips #00 screwdriver or your fingers to remove the rubber tabs at top back of the phone. Use a Phillips #00 screwdriver or your fingers to remove the rubber tabs at top back of the phone.
  • Use a Phillips #00 screwdriver or your fingers to remove the rubber tabs at top back of the phone.

Voeg opmerking toe

Remove four 5mm screws from the back of the phone using a T6 Torx screwdriver: 2 screws at the bottom
  • Remove four 5mm screws from the back of the phone using a T6 Torx screwdriver:

    • 2 screws at the bottom

    • 2 screws at the top

Voeg opmerking toe

Rotate the phone clockwise so the edge is facing you. Insert the spudger in tabs between the outer casing and the inside frame.
  • Rotate the phone clockwise so the edge is facing you.

  • Insert the spudger in tabs between the outer casing and the inside frame.

  • Slide the spudger upwards.

    • This will remove the rear case of the phone.

Voeg opmerking toe

The phone should now be in two different sections.
  • The phone should now be in two different sections.

    • 1) The rear case of the phone.

    • 2) The motherboard and the rest of the phone.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Jonathan Newman

Lid sinds: 21-01-11

486 reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 1-14, Amido Winter 2011 Lid van Cal Poly, Team 1-14, Amido Winter 2011

CPSU-AMIDO-W11S1G14

5 Leden

16 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,429