Ga door naar hoofdinhoud

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

Disassembling IBM ThinkPad A30 CPU Fan

Wat je nodig hebt

  1. Disassembling IBM ThinkPad A30 CPU Fan, Battery: stap 1, afbeelding 1 van 2 Disassembling IBM ThinkPad A30 CPU Fan, Battery: stap 1, afbeelding 2 van 2
    • Flip the ThinkPad over so that it is upside down.

    • Slide the highlighted tab to the left.

    • With your finger on the tab, remove the battery by lifting it upwards away from the laptop.

  2. Disassembling IBM ThinkPad A30 CPU Fan, Upper Case: stap 2, afbeelding 1 van 1
    • Make sure the laptop is upside down and oriented in the direction shown.

    • Remove the six 16.7mm screws inside the circled holes.

  3. Disassembling IBM ThinkPad A30 CPU Fan: stap 3, afbeelding 1 van 1
    • Rotate the ThinkPad so that the hard drive bay is facing you.

    • Remove the black cover to reveal a 14.8mm screw.

    • Remove the uncovered screw with a Phillips #0 screwdriver.

  4. Disassembling IBM ThinkPad A30 CPU Fan: stap 4, afbeelding 1 van 2 Disassembling IBM ThinkPad A30 CPU Fan: stap 4, afbeelding 2 van 2
    • Flip the ThinkPad over and open the LCD panel.

    • Pry apart the keyboard with a plastic opening tool or with your fingers.

  5. Disassembling IBM ThinkPad A30 CPU Fan: stap 5, afbeelding 1 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 5, afbeelding 2 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 5, afbeelding 3 van 3
    • Be careful not to pull out the keyboard carelessly; there is a connector underneath it!

    • Lift the front end of the keyboard as shown.

    • Using your fingers, remove the black film cover.

  6. Disassembling IBM ThinkPad A30 CPU Fan: stap 6, afbeelding 1 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 6, afbeelding 2 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 6, afbeelding 3 van 3
    • Locate the connector attached to the motherboard.

    • Disconnect the ribbon cable by removing the connector.

  7. Disassembling IBM ThinkPad A30 CPU Fan: stap 7, afbeelding 1 van 2 Disassembling IBM ThinkPad A30 CPU Fan: stap 7, afbeelding 2 van 2
    • Lift and remove the keyboard.

    • Remove the two 5.6mm screws.

    • Remove the 16.7mm screw.

  8. Disassembling IBM ThinkPad A30 CPU Fan: stap 8, afbeelding 1 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 8, afbeelding 2 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 8, afbeelding 3 van 3
    • You will need to use a little force. Be wary of the tabs.

    • Pry off the upper case with your hands.

  9. Disassembling IBM ThinkPad A30 CPU Fan, Display Assembly: stap 9, afbeelding 1 van 1
    • Remove the 5.6mm screw that holds the LCD to the upper case.

  10. Disassembling IBM ThinkPad A30 CPU Fan: stap 10, afbeelding 1 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 10, afbeelding 2 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 10, afbeelding 3 van 3
    • Remove the 5.6mm screw on the left side of the three-pronged connector.

    • Remove the other two 16.7mm screws.

    • Lift and remove connector.

  11. Disassembling IBM ThinkPad A30 CPU Fan: stap 11, afbeelding 1 van 2 Disassembling IBM ThinkPad A30 CPU Fan: stap 11, afbeelding 2 van 2
    • Pull out the white tab connecting the LCD to the motherboard.

  12. Disassembling IBM ThinkPad A30 CPU Fan: stap 12, afbeelding 1 van 2 Disassembling IBM ThinkPad A30 CPU Fan: stap 12, afbeelding 2 van 2
    • Turn the laptop so that the back is facing you.

    • Remove the four 5.6mm long screws.

  13. Disassembling IBM ThinkPad A30 CPU Fan: stap 13, afbeelding 1 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 13, afbeelding 2 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 13, afbeelding 3 van 3
    • Place the laptop so that the LCD is facing you again.

    • Gently lift the LCD monitor up and out.

    • Remove the black plastic tab.

  14. Disassembling IBM ThinkPad A30 CPU Fan, CPU Fan: stap 14, afbeelding 1 van 1
    • Locate the 4 screws that will need to be removed.

    • One screw (yellow) is observable. The three other screws (red) are below the heatsink bracket.

    • Remove the 5.6mm (yellow) and three 16.1mm (red) screws.

  15. Disassembling IBM ThinkPad A30 CPU Fan: stap 15, afbeelding 1 van 1
    • Lift the heatsink bracket up.

  16. Disassembling IBM ThinkPad A30 CPU Fan: stap 16, afbeelding 1 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 16, afbeelding 2 van 3 Disassembling IBM ThinkPad A30 CPU Fan: stap 16, afbeelding 3 van 3
    • Be careful not to pull too hard! There is a cable attached to the fan!

    • Lift the fan/heatsink assembly up.

    • Locate the fan power cable and pull upwards near the connector.

    • Remove the fan/heatsink assembly.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Jessica

Lid sinds: 10/06/10

162 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 4-44, Amido Fall 2010 Lid van Cal Poly, Team 4-44, Amido Fall 2010

CPSU-AMIDO-F10S4G44

4 Leden

26 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 4

Altijd: 2,593