Inleiding

The LCD display can be removed and replaced if it is cracked or broken.

Onderdelen

Geen onderdelen nodig.

Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.
  • Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.

  • Remove the 2 screws(4.08mm) on the other side. One is located under the rubber USB flap.

  • Remove the last screw(2.59mm) located on the bottom of the camera.

  • Slowly pull the back cover of the camera.

Voeg opmerking toe

Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.
  • Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.

  • Disconnect the ribbons connecting the screen to the camera.

  • Remove the screen by lifting it off.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Ben Tupas

Lid sinds: 13-01-11

317 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 13-3, Forte Winter 2011 Lid van Cal Poly, Team 13-3, Forte Winter 2011

CPSU-FORTE-W11S13G3

5 Leden

8 handleidingen geschreven

Één commentaar

Hm. "Disconnect the ribbons" resulted in a torn ribbon, and so a dead camera, I think. This also doesn't say how to take the LCD screen out of its frame. Alas.

Maelduin - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 2,152