Ga door naar hoofdinhoud

Disassembling Canon PowerShot SD800 IS LCD Display

Wat je nodig hebt

  1. Disassembling Canon PowerShot SD800 IS LCD Display, Back Cover: stap 1, afbeelding 1 van 1
    • Remove one 2.25mm screw on the bottom.

  2. Disassembling Canon PowerShot SD800 IS LCD Display: stap 2, afbeelding 1 van 1
    • Remove two 2.25mm screws on the right side looking from the front.

  3. Disassembling Canon PowerShot SD800 IS LCD Display: stap 3, afbeelding 1 van 1
    • Remove one 4.7mm screw on the side with the AV output.

  4. Disassembling Canon PowerShot SD800 IS LCD Display: stap 4, afbeelding 1 van 1
    • Pull off the back cover.

    • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

  5. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Assembly: stap 5, afbeelding 1 van 1
    • Remove 2 2.4mm screws on bottom.

  6. Disassembling Canon PowerShot SD800 IS LCD Display: stap 6, afbeelding 1 van 1
    • Follow the small data cable to where it connects to the camera.

    • Lift the back white portion to unlock the cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  7. Disassembling Canon PowerShot SD800 IS LCD Display: stap 7, afbeelding 1 van 1
    • Gently lift LCD display off.

    • There will be two data cables still attached to the camera. Do not break them.

    • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

  8. Disassembling Canon PowerShot SD800 IS LCD Display: stap 8, afbeelding 1 van 1
    • Follow the larger cable to where it connects to the camera.

    • Lift the front black portion of the connector to unlock the data cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  9. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Display: stap 9, afbeelding 1 van 1
    • Pry the LCD display out from the four metal clamps.

  10. Disassembling Canon PowerShot SD800 IS LCD Display: stap 10, afbeelding 1 van 1
    • To remove the LCD, peel the larger data cable off from the frame.

    • The LCD is glued by its data cable to the back of the LCD frame.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Lid sinds: 10/10/10

135 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 20-9, Maness Fall 2010 Lid van Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 2,689