Inleiding

Removing the front cover allows access to the flash assembly.

Onderdelen

Geen onderdelen nodig.

Remove one 2.25mm screw on the bottom.
  • Remove one 2.25mm screw on the bottom.

Voeg opmerking toe

Remove two 2.25mm screws on the right side looking from the front.
  • Remove two 2.25mm screws on the right side looking from the front.

Voeg opmerking toe

Remove one 4.7mm screw on the side with the AV output.
  • Remove one 4.7mm screw on the side with the AV output.

Voeg opmerking toe

Pull off the back cover.
  • Pull off the back cover.

  • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

Voeg opmerking toe

Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.
  • Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.

Voeg opmerking toe

Remove one 2.25mm screw on the bottom of the camera.
  • Remove one 2.25mm screw on the bottom of the camera.

Voeg opmerking toe

Pull off the front cover.
  • Pull off the front cover.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Lid sinds: 10-10-10

135 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 20-9, Maness Fall 2010 Lid van Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 2,271