Inleiding

Use this guide to remove the front and rear cover of the Canon PowerShot SD1100 IS.

Onderdelen

Geen onderdelen nodig.

Remove wrist strap and battery. Remove wrist strap and battery.
  • Remove wrist strap and battery.

Voeg opmerking toe

Remove 2 screws from each side of the camera (4 total, 0.102 in). Remove 2 screws from the bottom on the camera (0.138 in). Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.
  • Remove 2 screws from each side of the camera (4 total, 0.102 in).

  • Remove 2 screws from the bottom on the camera (0.138 in).

  • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

Voeg opmerking toe

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Gently pull off the front cover. The plate on the side should come off. Gently pull off the back cover.
  • Gently pull off the front cover.

  • The plate on the side should come off.

  • Gently pull off the back cover.

Voeg opmerking toe

The cases should now be removed.
  • The cases should now be removed.

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore - Antwoord

oh yes , i agree lol

elbala80 -

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Tyler Grossheim

Lid sinds: 25-01-11

1.359 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 3-32, Regan Winter 2011 Lid van Cal Poly, Team 3-32, Regan Winter 2011

CPSU-REGAN-W11S3G32

3 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 3,135