Inleiding

Use this guide to replace a dysfunctional back cover.

Onderdelen

Geen onderdelen nodig.

Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

Voeg opmerking toe

On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

Voeg opmerking toe

Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
  • Remove the three long black screws from the bottom using a #00 Phillips screwdriver.

  • Use tweezers to lift the panel.

Voeg opmerking toe

Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
  • Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Daniel Bussone

Lid sinds: 28-01-11

1.206 Reputatie

11 handleidingen geschreven

Team

Cal Poly, Team 3-41, Regan Winter 2011 Lid van Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 Leden

11 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 11

Altijd: 3,465