Inleiding

As a first step to clean, maintain, or install new parts (excluding the blender blades) for the Black and Decker BL3000S the blender base must be taken apart. This guide will provide step by step instructions of how to perform this task.

  1. Before disassembling the blender base, make sure the blender disconnected from any power outlet.
    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

    Voeg opmerking toe

  2. Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

    Voeg opmerking toe

  3. Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK bij het afrekenen
    Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK
    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

    Voeg opmerking toe

    • Remove the following screws that secure the top and bottom halves of the base.

      • One 1/4 Phillips screw

      • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

    Voeg opmerking toe

    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Andrew

Lid sinds: 04-10-12

170 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 6-34, Regan Fall 2012 Lid van Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 14

Afgelopen 30 Dagen: 66

Altijd: 3,780