Inleiding

This is the beginning process to remove or replace any functional component in the AirPort.

Onderdelen

Geen onderdelen nodig.

  1. Remove the three 5mm T7 Torx screws from the back panel.
    • Remove the three 5mm T7 Torx screws from the back panel.

    Voeg opmerking toe

  2. Remove one 5mm phillips screw located under the identification sticker.  You will need to remove the sticker or make a hole to get to the screw.
    • Remove one 5mm phillips screw located under the identification sticker. You will need to remove the sticker or make a hole to get to the screw.

    Voeg opmerking toe

    • Separate the bottom and top casings.

    Voeg opmerking toe

    • Remove the metal case from the top case of the AirPort, there are no screws holding it on.

    • Remove the four screws from the metal casing.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Michael Garcia

Lid sinds: 12-10-11

369 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 17-15, Regan Fall 2011 Lid van Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 17

Altijd: 1,703