Repareer je spullen Gemeenschap Winkel

Digital2 D2-912 Motherboard Replacement

Inleiding

This repair is necessary if the motherboard of the Digital2 D2-912 becomes defective at any point. Repairing the motherboard will help overall performance, as it establishes a connection from the hardware of the device to the processor. Special skills are not required to complete this repair. This manual highlights the necessary steps and tools for successful completion.

Wat je nodig hebt

  1. Digital2 D2-912 Motherboard Replacement, External Cover: stap 1, afbeelding 1 van 1

    • Remove the two Phillips #00 screws from the bottom of the case.

    Bewerken

  2. Digital2 D2-912 Motherboard Replacement: stap 2, afbeelding 1 van 2 Digital2 D2-912 Motherboard Replacement: stap 2, afbeelding 2 van 2

    • Wedge the opening tool in the space between the back and the front of the tablet.

    • Carefully work your way around the perimeter, wedging the opening tool between the front and back of the tablet.

    • When the back of the tablet is mostly detached from the front, carefully pull it away completely.

    Bewerken

  4. Digital2 D2-912 Motherboard Replacement, Motherboard: stap 3, afbeelding 1 van 1
    Gereedschap gebruikt in deze stap:
    Desoldering Pump
    $3.99
    Koop

    • Remove the wires shown in the image, using a soldering iron and solder sucker.

    • By removing the wires, you are detaching the battery and speaker from the motherboard.

    Bewerken

  5. Digital2 D2-912 Motherboard Replacement: stap 4, afbeelding 1 van 1

    • Use the Phillips #00 screwdriver to remove the three screws from motherboard.

    Bewerken

  6. Digital2 D2-912 Motherboard Replacement: stap 5, afbeelding 1 van 2 Digital2 D2-912 Motherboard Replacement: stap 5, afbeelding 2 van 2

    • Detach the capacitive touch controller from the motherboard.

    • Carefully pry the narrow black connector upward to release the ribbon.

    • Remove the ribbon from the connector.

    Bewerken

  7. Digital2 D2-912 Motherboard Replacement: stap 6, afbeelding 1 van 1

    • Locate the camera found in the image.

    • Carefully pry the black connector upward to release ribbon.

    • Remove the black tape to release the camera from the motherboard.

    • Remove the ribbon from the connector.

    • Remove and replace the motherboard.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Auteur

met 7 andere bijdragers

Jason Wignot

Lid sinds: 09/16/15

322 Reputatie

3 handleidingen geschreven

Medailles: 12

+9 andere badges

Team

IUPUI, Team 1-1, Harley Fall 2015 Lid van IUPUI, Team 1-1, Harley Fall 2015

IUPUI-HARLEY-F15S1G1

4 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 370