Ga door naar hoofdinhoud

DigiLand DL8006 Internal Ribbon Replacement

Wat je nodig hebt

  1. DigiLand DL8006 Internal Ribbon Replacement, Internal Ribbon: stap 1, afbeelding 1 van 3 DigiLand DL8006 Internal Ribbon Replacement, Internal Ribbon: stap 1, afbeelding 2 van 3 DigiLand DL8006 Internal Ribbon Replacement, Internal Ribbon: stap 1, afbeelding 3 van 3
    • Flip the tablet to where its back is facing upward.

    • Remove the back cover by prying the sides with a plastic opening tool.

    • Lay the opened device with the circuit board exposed.

  2. DigiLand DL8006 Internal Ribbon Replacement: stap 2, afbeelding 1 van 2 DigiLand DL8006 Internal Ribbon Replacement: stap 2, afbeelding 2 van 2
    • Remove the silver/metallic tape covering the blue and red wires overlapping the upper and lower end of the ribbon cable.

  3. DigiLand DL8006 Internal Ribbon Replacement: stap 3, afbeelding 1 van 3 DigiLand DL8006 Internal Ribbon Replacement: stap 3, afbeelding 2 van 3 DigiLand DL8006 Internal Ribbon Replacement: stap 3, afbeelding 3 van 3
    • Remove the ribbon cable by pulling the locking tab of the ZIF connector up and pulling the ribbon cable out with tweezers.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Landon Choi

Lid sinds: 10/30/19

379 Reputatie

3 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 137