Ga door naar hoofdinhoud

Inleiding

Before the majority of components can be accessed to be replaced, the back panel will need to come off.

Onderdelen

Geen onderdelen opgegeven.

  1. Turn the laptop upside down.
    • Turn the laptop upside down.

    • Make sure the laptop is turned off.

    • Using a T5 Torx Screwdriver, remove the ten 3 mm long screws from the perimeter of the back of the laptop.

  2. Open up the information panel door (on the middle of the back side). While holding the door open, use a Phillips #00 Screwdriver to remove the two 10 mm long screws.
    • Open up the information panel door (on the middle of the back side).

    • While holding the door open, use a Phillips #00 Screwdriver to remove the two 10 mm long screws.

  3. Carefully lift the 2 corners of the back panel close to the hinge upwards, releasing the whole panel. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.
    • Carefully lift the 2 corners of the back panel close to the hinge upwards, releasing the whole panel.

    • Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.

Conclusie

To reassemble your device, follow these instructions in reverse order.

9 andere personen hebben deze handleiding voltooid.

Brandon Schmidt

Lid sinds: 04-10-18

1.432 Reputatie

3 handleidingen geschreven

Team

UW Stout, Team S6-G1, Ogden Fall 2018 Lid van UW Stout, Team S6-G1, Ogden Fall 2018

UWSTOUT-OGDEN-F18S6G1

4 Leden

21 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 28

Afgelopen 30 dagen: 128

Altijd: 7,455