Ga door naar hoofdinhoud

Inleiding

This replacement guide will show you how to replace the auxiliary (aux) cord on your Dell VRP100 headset. Most audio-related issues will stem from the aux cord so it is important to replace it to ensure the highest audio quality.

  1. Remove the black foam padding by peeling away slowly. Remove the front and back padding from the headset by peeling away slowly. Remove the front and back padding from the headset by peeling away slowly.
    • Remove the black foam padding by peeling away slowly.

    • Remove the front and back padding from the headset by peeling away slowly.

  2. Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
    • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

    • Cover panel may need to be pushed in before inserting screws.

  3. Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing. Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing. Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.
    • Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

  4. iPhone Batterij Fix Kits

    Slechts $29.99

    Buy Now

    iPhone Batterij Fix Kits

    Slechts $29.99

    Buy Now
  5. Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise. Carefully remove the lens and motherboard assembly from the white casing. Carefully remove the lens and motherboard assembly from the white casing.
    • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

    • Carefully remove the lens and motherboard assembly from the white casing.

  6. Separate the external connector of the auxiliary cord. A spudger may be needed to separate the connector. A spudger may be needed to separate the connector.
    • Separate the external connector of the auxiliary cord.

    • A spudger may be needed to separate the connector.

  7. Remove the four 2.5mm PH000 screws by rotating counter-clockwise. Separate the lens housing from the motherboard panel.
    • Remove the four 2.5mm PH000 screws by rotating counter-clockwise.

    • Separate the lens housing from the motherboard panel.

  8. In the top right corner of the motherboard panel, peel back the yellow tape covering the bundled auxiliary cable connector using tweezers. Carefully pull out the bundled cable connectors. Carefully pull out the bundled cable connectors.
    • In the top right corner of the motherboard panel, peel back the yellow tape covering the bundled auxiliary cable connector using tweezers.

    • Carefully pull out the bundled cable connectors.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Chris Grabow

Lid sinds: 08-10-18

255 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team S17-G1, White Fall 2018 Lid van Cal Poly, Team S17-G1, White Fall 2018

CPSU-WHITE-F18S17G1

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 12

Altijd: 118