Ga door naar hoofdinhoud

Onderdelen

  1. Turn the laptop over so that the bottom is facing up. Remove the two #0 3 mm screws holding the cover plate.
    • Turn the laptop over so that the bottom is facing up.

    • Remove the two #0 3 mm screws holding the cover plate.

  2. Push both metal retaining clips outward at the same time using your hands carefully.
    • Push both metal retaining clips outward at the same time using your hands carefully.

    • If done correctly the memory should pop up at a 45 degree angle.

  3. Koop geen nieuw model.

    Bespaar $10 op $50 met coupon
    SKIPANDSAVE10

    Bespaar nu

    Koop geen nieuw model.

    Take $10 off $50 with
    SKIPANDSAVE10

    Bespaar nu
  4. Gently pull the memory out of the retainer at the same 45 degree angle.
    • Gently pull the memory out of the retainer at the same 45 degree angle.

  5. Insert the new memory at 45 degree angle.
    • Insert the new memory at 45 degree angle.

  6. Ensure the memory is in all the way before pressing the memory downward until both metal retainer clips are snapped into place.
    • Ensure the memory is in all the way before pressing the memory downward until both metal retainer clips are snapped into place.

Conclusie

To reassemble your device, reinstall cover plate with two #0 screws.

Thomas Wong

Lid sinds: 20-01-12

23 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 11-20, Maness Winter 2012 Lid van Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 3

Altijd: 2,026