Onderdelen

Geen onderdelen nodig.

Before removing the battery from the laptop, make sure the power is off.
  • Before removing the battery from the laptop, make sure the power is off.

  • Push both battery locking clips outward at the same time.

Voeg opmerking toe

Slide the battery out of the laptop.
  • Slide the battery out of the laptop.

Voeg opmerking toe

Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.
  • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

Voeg opmerking toe

Carefully turn the laptop over and open the screen all the way. Locate the slot to remove the keyboard in the lower left hand corner.
  • Carefully turn the laptop over and open the screen all the way.

  • Locate the slot to remove the keyboard in the lower left hand corner.

  • Using a spudger as a lever, insert it into the slot and gently pry up.

Voeg opmerking toe

After the keyboard pops up, pull it away from the screen just enough to release the tabs.
  • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

  • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

Voeg opmerking toe

Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.
  • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

Voeg opmerking toe

Remove the flexible ribbon from ZIF connector.
  • Remove the flexible ribbon from ZIF connector.

  • Do not pull on the ribbon to remove it from the ZIF connector.

Voeg opmerking toe

Position the laptop so that the bottom is facing upward.
  • Position the laptop so that the bottom is facing upward.

  • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

Voeg opmerking toe

Return the laptop to proper position and open the screen.
  • Return the laptop to proper position and open the screen.

  • Remove the 6 #0 4 mm screws holding in the palm rest.

Voeg opmerking toe

Gently lift the palm rest and rotate it outward so that the bottom is now facing up.
  • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

  • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

Voeg opmerking toe

Lift up on the small ZIF connector and remove ribbon.
  • Lift up on the small ZIF connector and remove ribbon.

  • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

Voeg opmerking toe

Remove the 4 3 mm screws that hold the cooling fan to the system board.
  • Remove the 4 3 mm screws that hold the cooling fan to the system board.

Voeg opmerking toe

Remove the tape holding the cooling fan wires down.
  • Remove the tape holding the cooling fan wires down.

Voeg opmerking toe

Unplug the cooling fan wires from the system board by gently pulling on the hard molded plastic portion.
  • Unplug the cooling fan wires from the system board by gently pulling on the hard molded plastic portion.

  • Be careful not to damage the wires by tugging on them.

Voeg opmerking toe

Lift the cooling fan out of the laptop.
  • Lift the cooling fan out of the laptop.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Taylor Bateman

Lid sinds: 20-01-12

93 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 11-20, Maness Winter 2012 Lid van Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 1,194