Onderdelen

Geen onderdelen nodig.

  1. Before removing the battery from the laptop, make sure the power is off.
    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

    Voeg opmerking toe

  2. Slide the battery out of the laptop.
    • Slide the battery out of the laptop.

    Voeg opmerking toe

    • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

    Voeg opmerking toe

    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

    Voeg opmerking toe

    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

    Voeg opmerking toe

    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

    Voeg opmerking toe

    • Remove the flexible ribbon from ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

    Voeg opmerking toe

    • Position the laptop so that the bottom is facing upward.

    • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

    Voeg opmerking toe

    • Return the laptop to proper position and open the screen.

    • Remove the 6 #0 4 mm screws holding in the palm rest.

    Voeg opmerking toe

    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

    Voeg opmerking toe

    • Lift up on the small ZIF connector and remove ribbon.

    • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

    Voeg opmerking toe

    • Remove the #00 4 mm screws holding the speakers in place.

    Voeg opmerking toe

    • Gently pull the speaker cable out.

    • If the wire is tight, wiggle it back and forth but don’t apply too much force.

    • Do not use the speaker wire to pull itself out of the connector.

    Voeg opmerking toe

    • Pull the speakers straight up and out of the laptop.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Elai Fresco

Lid sinds: 20-01-12

7 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 11-20, Maness Winter 2012 Lid van Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 877