Inleiding

Guide to separating the display from the body of the laptop.

Onderdelen

Geen onderdelen nodig.

  1. Power down the laptop and remove the battery.
    • Power down the laptop and remove the battery.

    • Open the laptop cover all of the way.

    Voeg opmerking toe

  2. Locate the notch under the cover at the top of the keyboard
    • Locate the notch under the cover at the top of the keyboard

    • Using the spudger as a lever, lift the plastic covering

    • Carefully remove the rest of the covering from right to left

    Voeg opmerking toe

    • Unscrew the top portion of the keyboard using a #00 screwdriver

    Voeg opmerking toe

    • Hold keyboard from the top and gently pull towards the LCD screen to remove the keyboard from the case

    • Don't pull on the keyboard too forcefully because it is attached to the motherboard with a short, thin ribbon cable

    Voeg opmerking toe

    • Once keyboard is out of the case, lay it face-down on the track pad

    Voeg opmerking toe

    • Using a small spudger, pull back on the black bar to release the blue lever

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Pull up on the metal bar connected to the socket to detach the ribbon cable

    Voeg opmerking toe

    • Detach cables that connect the display to the body of the laptop

    Voeg opmerking toe

    • Disconnect the black cable attached to the motherboard

    Voeg opmerking toe

    • Close the laptop lid

    • Turn the laptop over onto its backside

    • Unscrew the two screws shown in the picture using a #00 screwdriver

    Voeg opmerking toe

    • Face the laptop's back ports towards you

    • Unscrew the two screws labeled in the picture using a #00 screwdriver

    Voeg opmerking toe

    • Turn the laptop over again so it's right-side up

    • Open the display, and pull the display up and out of the laptop's body

    Voeg opmerking toe

    • Remove the circular rubber pads as outlined in the picture using a spudger

    Voeg opmerking toe

    • Unscrew the screws that were under the rubber circles using the #00 screwdriver

    Voeg opmerking toe

    • Carefully use a spudger to work around the edge of the screen to lift off the plastic cover

    • Be very careful while doing this as the plastic snaps easily

    Voeg opmerking toe

    • Remove the screws outlined in the picture

    Voeg opmerking toe

    • Carefully lift the LCD screen out of its casing

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

14 andere personen hebben deze handleiding voltooid.

Miguel Wong

Lid sinds: 15-04-10

449 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 24-35, Regan Spring 2010 Lid van Cal Poly, Team 24-35, Regan Spring 2010

CPSU-REGAN-S10S24G35

4 Leden

4 handleidingen geschreven

Één commentaar

Check out this replacement screen at a great price on bcdelectrostore.com

http://www.bcdelectrostore.com/magento/l...

bob harris - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 9

Afgelopen 30 Dagen: 66

Altijd: 30,708