Repareer je spullen Gemeenschap Winkel

Dell Latitude D430 Wireless Adapter Replacement

Geschreven door: Parker Wiley (en 2 andere bijdragers)
  • Reacties: 0
  • Favorieten: 0

Moeilijkheid

Gemiddeld

Stappen

6

Tijd vereist

5 minuten

Secties

1

Markeringen

0

Inleiding

The wireless adapter allows you to connect to local networks. This part is important because it allows you to use the internet. If you do not want to be tethered to a cable, it is important to replace this component if it does not function correctly.

Gereedschap

Onderdelen

Geen onderdelen opgegeven.

  1. Flip the laptop so you are able to see the bottom. Flip the laptop so you are able to see the bottom. Flip the laptop so you are able to see the bottom.

    • Flip the laptop so you are able to see the bottom.

    Bewerken

  2. Use a Phillips #00 screwdriver to remove the three screws that secure the small "L" shaped backplate. Use a Phillips #00 screwdriver to remove the three screws that secure the small "L" shaped backplate.

    • Use a Phillips #00 screwdriver to remove the three screws that secure the small "L" shaped backplate.

    Bewerken

  4. Once all 3 screws have been removed, carefully remove the panel by grabbing the edges, and pulling up.

    • Once all 3 screws have been removed, carefully remove the panel by grabbing the edges, and pulling up.

    Bewerken

  5. Identify the two pins connecting the wireless adapter to the motherboard. (The wireless adapter will say WLAN on it.) Carefully pull up on each pin and remove them from the wireless adapter. Note that there are no wires/cables connecting the wireless adapter to the motherboard.

    • Identify the two pins connecting the wireless adapter to the motherboard. (The wireless adapter will say WLAN on it.)

    • Carefully pull up on each pin and remove them from the wireless adapter.

    • Note that there are no wires/cables connecting the wireless adapter to the motherboard.

    Bewerken

  6. Pull back on the two metal tabs holding the wireless adapter down. After the two metal tabs are pulled, the card will pop up.

    • Pull back on the two metal tabs holding the wireless adapter down.

    • After the two metal tabs are pulled, the card will pop up.

    Bewerken

  7. Pull the wireless adapter out away from where it was connected.

    • Pull the wireless adapter out away from where it was connected.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 2 andere bijdragers

Parker Wiley

Lid sinds: 21-06-18

382 Reputatie

3 handleidingen geschreven

Badges: 7

+4 andere badges

Team

University of North Texas, Team S2-G1, Riccardelli Fall 2018 Lid van University of North Texas, Team S2-G1, Riccardelli Fall 2018

UNT-RICCARDELLI-F18S2G1

3 Leden

4 handleidingen geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 4

Altijd: 339