Inleiding

Make sure to disconnect the battery before replacing the hard drive.

  1. Turn off laptop before beginning.
    • Turn off laptop before beginning.

    • Place the laptop upside down on a flat, stable surface.

  2. Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver. Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.
    • Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.

  3. Remove the panel from the sides and pull it out at an angle towards you.
    • Remove the panel from the sides and pull it out at an angle towards you.

  4. Gratis verzending van alle bestellingen van meer dan US$ 100 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  5. Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown. Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown.
    • Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown.

  6. Disconnect the power cord from the battery  by using a pair of tweezers, your fingers, or the opening tools from the iFixit pro tech tool kit. Pinch the clips on the left and right side while pulling on the cord at the same time.
    • Disconnect the power cord from the battery by using a pair of tweezers, your fingers, or the opening tools from the iFixit pro tech tool kit.

    • Pinch the clips on the left and right side while pulling on the cord at the same time.

  7. Pull the battery towards you.
    • Pull the battery towards you.

    • Make sure to pull at an upward angle.

  8. Remove the four 5mm screws with a Phillips #1 screwdriver. Remove the four 5mm screws with a Phillips #1 screwdriver.
    • Remove the four 5mm screws with a Phillips #1 screwdriver.

  9. Remove the cable from the motherboard that is attached to the Hard Drive. Use your fingers or the plastic opening tools to gently pull up on the clip, freeing the cable. Use your fingers or the plastic opening tools to gently pull up on the clip, freeing the cable.
    • Remove the cable from the motherboard that is attached to the Hard Drive.

    • Use your fingers or the plastic opening tools to gently pull up on the clip, freeing the cable.

  10. Lift and remove Hard Drive.
    • Lift and remove Hard Drive.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 5

Altijd: 90