Inleiding

Use this guide to replace a damaged display bezel.

Onderdelen

Geen onderdelen nodig.

  1. Lay the monitor screen-down so the back screws are exposed.
    • Lay the monitor screen-down so the back screws are exposed.

    • Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.

    Voeg opmerking toe

  2. Gently lift and pull away the stand at a slight angle away from the monitor.
    • Gently lift and pull away the stand at a slight angle away from the monitor.

    Voeg opmerking toe

    • Locate the two holes on the bottom of the monitor.

    • Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.

    • This task is much easier if two people pry simultaneously at each hole.

    • Continue prying along the entire edge of the monitor.

    Voeg opmerking toe

    • When finished prying, the plastic will partially fall away from the rest of the monitor.

    • Do not try to fully remove the front frame yet. The frame is still attached to the buttons.

    • While holding the frames together, carefully flip the monitor over so it faces screen down.

    • Gently lift and remove remove the rear case from the monitor.

    Voeg opmerking toe

    • Locate the green interface button board.

    • Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.

    • Lift the monitor interior away from the front cover.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Mackenzie Keane

Lid sinds: 04-10-11

475 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 5-36, Amido Fall 2011 Lid van Cal Poly, Team 5-36, Amido Fall 2011

CPSU-AMIDO-F11S5G36

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 2

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 10

Altijd: 3,319