Repareer je spullen

Recht op reparatie

Winkel

Dell Dimension 4600 Optical Drive Replacement

Geschreven door: Eugene (en 4 andere bijdragers)
  • Reacties: 0
  • Favorieten: 5
  • Voltooide reparaties: 11

Moeilijkheid

Gemiddeld

Stappen

11

Tijd vereist

10 - 15 minuten

Secties

2

Markeringen

2

Needs Better Images

Heeft betere plaatjes nodig

Betere foto's zullen deze handleiding verbeteren. Help mee door het nemen, bewerken of uploaden van nieuwe foto's!

Markup Mishap

Mislukte opmaak

Deze handleiding heeft een betere opmaak nodig. Help mee door het corrigeren van de opmaak of door aantekeningen te maken.

Inleiding

Use this guide to replace the optical drive in your computer.

Gereedschap

Koop deze gereedschappen

Onderdelen

Geen onderdelen opgegeven.

  1. Locate the case cover latch on the back of the computer.

    • Locate the case cover latch on the back of the computer.

    Bewerken

  2. Using your index finger, slide and hold the cover latch down.

    • Using your index finger, slide and hold the cover latch down.

    • While holding the latch down, place your other hand flat on the side of the case and firmly shift the side panel to the left until it disengages.

    Bewerken

  3. Grab the edge of the panel and slide it away from the case until it is removed.

    • Grab the edge of the panel and slide it away from the case until it is removed.

    Bewerken

  4. Locate the Optical Drive by finding it externally on the case.

    • Locate the Optical Drive by finding it externally on the case.

    Bewerken

  6. Press and hold the two levers located behind the front panel. While holding the levers down, swing open the front panel.

    • Press and hold the two levers located behind the front panel.

    • While holding the levers down, swing open the front panel.

    Bewerken

  7. Swing the front of the case open until it separates from the main case.

    • Swing the front of the case open until it separates from the main case.

    Bewerken

  8. Lay the computer flat on it's side so that you are looking down on all of the components. Locate the Drive 1 cable and where it is connected to the motherboard. Locate the Drive 1 cable and where it is connected to the motherboard.

    • Lay the computer flat on it's side so that you are looking down on all of the components.

    • Locate the Drive 1 cable and where it is connected to the motherboard.

    Bewerken

  9. Grasp the end of the Drive 1 cable connected to the motherboard and firmly pull upwards until it is removed.

    • Grasp the end of the Drive 1 cable connected to the motherboard and firmly pull upwards until it is removed.

    Bewerken

  10. Locate the end of the Drive 1 cable connected to the optical drive. Grasp the cable and pull firmly to disconnect it from the optical drive.

    • Locate the end of the Drive 1 cable connected to the optical drive.

    • Grasp the cable and pull firmly to disconnect it from the optical drive.

    Bewerken

  11. Locate the screw on the optical drive. Remove the 7.7 mm screw by using a Phillips #2 screw-driver.

    • Locate the screw on the optical drive.

    • Remove the 7.7 mm screw by using a Phillips #2 screw-driver.

    Bewerken

  12. Remove the optical drive by sliding it out of the front of the case.

    • Remove the optical drive by sliding it out of the front of the case.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

11 andere personen hebben deze handleiding voltooid.

Auteur

met 4 andere bijdragers

Eugene

Lid sinds: 12-10-11

186 Reputatie

1 Handleiding geschreven

Badges: 7

+4 andere badges

Team

Cal Poly, Team 6-10, Regan Fall 2011 Lid van Cal Poly, Team 6-10, Regan Fall 2011

CPSU-REGAN-F11S6G10

4 Leden

11 handleidingen geschreven

0 Opmerkingen

Voeg een opmerking toe

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 28

Altijd: 5,930