1. Flip your bike so the seat and handlebars are on the ground.
    • Flip your bike so the seat and handlebars are on the ground.

  2. Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.
    • Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.

    • Make sure that the chain is on the correct side of the wheel

  3. Gratis verzending van alle bestellingen van meer dan US$ 100,00 of met een Pro Tech Toolkit!

    Doorblader onze winkel

    Ooit iets gerepareerd? Je bent een genie.

    Deel je reparatie met #ImAGenius

    We zijn allemaal genieën

    Deel je reparatie met #ImAGenius

  4. Tighten brake strap using screwdriver and 10mm socket wrench. Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.
    • Tighten brake strap using screwdriver and 10mm socket wrench. Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.

  5. Center the wheel and pull back to tighten the chain
    • Center the wheel and pull back to tighten the chain

  6. With wheel pulled back, tighten the two axle nuts using the 15mm socket wrench. Tighten the non-drive side (side without the chain) first.
    • With wheel pulled back, tighten the two axle nuts using the 15mm socket wrench. Tighten the non-drive side (side without the chain) first.

    • Wheel will angle as you tighten. Keep it centered with your hand as you finish tightening both axle nuts.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Erin Heimburge

Lid sinds: 11-07-13

27 Reputatie

1 Handleiding geschreven

Team

Weergavestatistieken:

Afgelopen 24 Uren: 4

Afgelopen 7 Dagen: 17

Afgelopen 30 Dagen: 62

Altijd: 5,614