Inleiding

The table guard is essential in making sure the Craftsman Model 315.10721 makes the desired cuts. Keep in mind when performing the replacement that disassembling the table guard is time consuming.

Onderdelen

Geen onderdelen nodig.

Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.
  • Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

Voeg opmerking toe

Pivot the table guard from its upright position to an angle.
  • Pivot the table guard from its upright position to an angle.

  • Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

Voeg opmerking toe

Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.
  • Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.

  • Carefully remove the main case to expose the inside of the saw.

Voeg opmerking toe

Remove the old table guard by gently lifting it away from the main case.
  • Remove the old table guard by gently lifting it away from the main case.

  • Replace the old table guard with the new one by placing it in the same orientation as the one removed.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Riley Hilliker

Lid sinds: 14-10-14

546 reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 4-47, Amido Fall 2014 Lid van Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 252