Inleiding

WARNING: Once the power cord has been identified as the item that needs replacement, make sure that the device is disconnected from any power supply.

  1. Remove the two 1" Phillips screws using a #1 Phillips screwdriver.
    • Remove the two 1" Phillips screws using a #1 Phillips screwdriver.

    • Remove the three 1/2" Phillips screws using a #1 Phillips screwdriver.

    • Once the five screws are removed, lift the handle cover from the saw.

    • Each screw has a corresponding nut on the opposite side of the power saw

    Voeg opmerking toe

  2. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
  3. Remove the 1/2" Phillips screw that is securing the switch using a Phillips #1 screwdriver.
    • Remove the 1/2" Phillips screw that is securing the switch using a Phillips #1 screwdriver.

    Voeg opmerking toe

    • Using a Phillips #00 screwdriver or a small diameter screwdriver, gently insert it into the leads. When the screwdriver is inserted into the lead, it will release the wire.

      • The leads are where the black and white wires from the power cord are plugged in.

    • Release both the black and white wires and gently pull them from the leads.

    • To install the new cord, insert the wires of the new cord in the same way that they were removed.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Riley Hilliker

Lid sinds: 14-10-14

546 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 4-47, Amido Fall 2014 Lid van Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 209