Inleiding

Often times it is only necessary to replace the carbon brushes, not the motor. Carbon brushes experience a lot of friction, and replacement is generally expected over time. Ensure your saw is unplugged before beginning the repair

Onderdelen

Geen onderdelen nodig.

  1. Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor. Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.
    • Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.

  2. Gratis verzending van alle bestellingen van meer dan US$ 100,00 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  3. Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.
    • Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.

      • The washer is seurely held in place and may require force to remove

  4. After the washers are removed, gently grab the old brushes and remove them from the motor.
    • After the washers are removed, gently grab the old brushes and remove them from the motor.

      • When reassembling make sure the curvature of the brushes match curvature of the motor.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Riley Hilliker

Lid sinds: 14-10-14

561 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 4-47, Amido Fall 2014 Lid van Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Leden

5 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 8

Altijd: 636