Ga door naar hoofdinhoud

Inleiding

The purpose of this guide is to show step-by-step instructions on how to replace the circuit board of a ColecoVision game controller.

Onderdelen

Geen onderdelen opgegeven.

  1. Unplug the controller from the game console. Unplug the controller from the game console.
    • Unplug the controller from the game console.

  2. Place the controller with the back panel up (buttons down). Remove the five 15mm screws on the back with a Phillips #1 screwdriver.
    • Place the controller with the back panel up (buttons down).

    • Remove the five 15mm screws on the back with a Phillips #1 screwdriver.

  3. Turn the device around.
    • Turn the device around.

    • Separate the front panel from the rest of the controller and set aside.

  4. Remove the tape and wiring holding the wires in place. Carefully lift the circuit board out of the controller.
    • Remove the tape and wiring holding the wires in place.

    • Carefully lift the circuit board out of the controller.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Juin Yeh

Lid sinds: 17-10-18

205 Reputatie

2 handleidingen geschreven

Team

UW Tacoma, Team S1-G2, Rose Fall 2018 Lid van UW Tacoma, Team S1-G2, Rose Fall 2018

UWT-ROSE-F18S1G2

4 Leden

12 handleidingen geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 9

Altijd: 543