Inleiding

This outer cover is the main cover that protects the inner electrical components. Perform the guide on a flat non-conductive surface to avoid electrical shock and damage to your device.

Onderdelen

Geen onderdelen nodig.

Turn the power switch, the leftmost knob, counterclockwise to off. Turn the power switch, the leftmost knob, counterclockwise to off.
  • Turn the power switch, the leftmost knob, counterclockwise to off.

Voeg opmerking toe

Turn the device around and firmly pull the power cable plug to remove it from the radio. Turn the device around and firmly pull the power cable plug to remove it from the radio.
  • Turn the device around and firmly pull the power cable plug to remove it from the radio.

Voeg opmerking toe

Unscrew the securing cap counterclockwise from the antenna connector. Unscrew the securing cap counterclockwise from the antenna connector.
  • Unscrew the securing cap counterclockwise from the antenna connector.

Voeg opmerking toe

Gently pull the antenna cable to remove it from the back of the radio. Gently pull the antenna cable to remove it from the back of the radio.
  • Gently pull the antenna cable to remove it from the back of the radio.

Voeg opmerking toe

Unscrew the cap counterclockwise on the microphone plug to disconnect the cable. Unscrew the cap counterclockwise on the microphone plug to disconnect the cable.
  • Unscrew the cap counterclockwise on the microphone plug to disconnect the cable.

Voeg opmerking toe

Gently unplug the microphone plug.
  • Gently unplug the microphone plug.

Voeg opmerking toe

Unscrew the top four 6.0mm Phillips head screws counterclockwise on the left and right side of the device using a #1 Phillips head screwdriver. Unscrew the top four 6.0mm Phillips head screws counterclockwise on the left and right side of the device using a #1 Phillips head screwdriver.
  • Unscrew the top four 6.0mm Phillips head screws counterclockwise on the left and right side of the device using a #1 Phillips head screwdriver.

Voeg opmerking toe

Gently life and remove the top cover. Gently life and remove the top cover. Gently life and remove the top cover.
  • Gently life and remove the top cover.

Voeg opmerking toe

Gently set down on a hard, flat, non-conductive surface to minimize risk of shock or breaking your radio. Carefully flip the radio over. Carefully flip the radio over.
  • Gently set down on a hard, flat, non-conductive surface to minimize risk of shock or breaking your radio.

  • Carefully flip the radio over.

Voeg opmerking toe

Unscrew the four 6.0mm Phillips head screws counterclockwise on the left and right side of the device that connect the remaining cover, using a #1 Phillips head screwdriver. Unscrew the four 6.0mm Phillips head screws counterclockwise on the left and right side of the device that connect the remaining cover, using a #1 Phillips head screwdriver.
  • Unscrew the four 6.0mm Phillips head screws counterclockwise on the left and right side of the device that connect the remaining cover, using a #1 Phillips head screwdriver.

Voeg opmerking toe

Watch out for the wires connected to the speaker. These short wires will not allow you to move the cover very far. Gently lift and remove the case cover. Gently lift and remove the case cover.
  • Watch out for the wires connected to the speaker. These short wires will not allow you to move the cover very far.

  • Gently lift and remove the case cover.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Chase

Lid sinds: 20-10-13

261 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 11-37, Amido Fall 2013 Lid van Cal Poly, Team 11-37, Amido Fall 2013

CPSU-AMIDO-F13S11G37

4 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 2

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 14

Altijd: 1,087