Inleiding

Swapping out the presser foot lets you create different stitches for different sewing tasks, such as buttonholes, zippers, zigzag, etc. Use this guide to change the presser foot in your sewing machine. We’re using a Bernina 830 for this procedure; sewing machines can vary, so check your sewing machine's owner’s manual for specific instructions.

Gereedschap

Geen gereedschap nodig.

Onderdelen

  1. Set the sewing machine needle to the upright position by turning the balance wheel towards you.
    • Set the sewing machine needle to the upright position by turning the balance wheel towards you.

    • Release the presser foot lever by sliding it up.

    • The presser foot will just fall out. Be ready to grab it.

    Voeg opmerking toe

  2. Pull the presser foot down and slide it off the peg on the machine.
    • Pull the presser foot down and slide it off the peg on the machine.

    • Be careful not to break the needle.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Grab your desired presser foot, and orient it foot-down.

    • Take the foot at an angle and slide the hole in the top of the presser foot onto the peg on the sewing machine.

    Voeg opmerking toe

    • Slide the presser foot lever down to lock the new foot in place.

    • Be sure to check your manual to see if you need to adjust the needle position. If it's not correctly adjusted, you may hit the needle on the presser foot and break the needle while sewing.

    Voeg opmerking toe

Eindstreep

Één andere persoon heeft deze handleiding voltooid.

Brittany McCrigler

Lid sinds: 05-03-12

80.050 Reputatie

132 handleidingen geschreven

Team

iFixit Lid van iFixit

Community

113 Leden

7.315 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 10

Afgelopen 7 Dagen: 117

Afgelopen 30 Dagen: 510

Altijd: 15,167