Inleiding
With the help of a screwdriver, you will be able to replace the silicon buttons, so you can hear some tunes again.
Wat je nodig hebt
-
-
Using a JIS-1 screwdriver, remove the seven 11 mm screws located on the back of the keyboard.
-
-
-
-
First, you will use a PH-1 bit to remove the 17 8mm screws circled in red.
-
Next, using the same PH-1 bit, you will remove the three 8mm screws hidden under the white wires, circled in orange.
-
Then, using a JIS-1 bit, we will remove three 7mm screws from the circuit board, circled in yellow.
-
After removing the circuit board, the last three screws are revealed, circled in green. You will use the PH-1 bit to remove these last screws.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 13-2, Banghart Winter 2017 Lid van Cal Poly, Team 13-2, Banghart Winter 2017
CPSU-BANGHART-W17S13G2
3 Leden
5 handleidingen geschreven
