Inleiding

This guide shows how to replace the cooling fan on the Selphy CP720. This is done to fix overheating problems caused by a faulty fan.

Onderdelen

Geen onderdelen nodig.

  1. Remove the four 8mm Phillips #1 screws from the bottom of the printer. Remove the four 8mm Phillips #1 screws from the bottom of the printer.
    • Remove the four 8mm Phillips #1 screws from the bottom of the printer.

  2. Gently lift the top half of the printer off its base
    • Gently lift the top half of the printer off its base

    • A data ribbon attaches the two halves, so don't pull hard and keep the two halves close together.

  3. Gratis verzending van alle bestellingen van meer dan US$ 100 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  4. Remove the side panel by lifting it out. Remove the side panel by lifting it out. Remove the side panel by lifting it out.
    • Remove the side panel by lifting it out.

  5. Unplug the fan from the circuit board by gently pulling on the wire connector at the base of the port. Do not tug on the wires.  Slowly increasing force as you pull is the best way to detach the wires.
    • Unplug the fan from the circuit board by gently pulling on the wire connector at the base of the port.

    • Do not tug on the wires. Slowly increasing force as you pull is the best way to detach the wires.

  6. Unscrew the two 8mm Phillips #1 screws from the fan.
    • Unscrew the two 8mm Phillips #1 screws from the fan.

    • Remove the fan from the panel.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Peter Ely

Lid sinds: 26-09-18

785 Reputatie

5 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 52