Inleiding

The outer case of the PowerShot SD550 is the part that takes the greatest beating. Every time the camera falls, it lands on its case. Some common problems include cracking and paint wear.

Onderdelen

Geen onderdelen nodig.

  1. In preparation for disassembly, the battery and SD Card need to be removed from the camera. You can access both the battery and the SD card through the door on the bottom of the camera.
    • In preparation for disassembly, the battery and SD Card need to be removed from the camera. You can access both the battery and the SD card through the door on the bottom of the camera.

    Voeg opmerking toe

  2. While being careful to remember the original location of each screw, remove the three 0.15 inch screws on the underside of the camera.
    • While being careful to remember the original location of each screw, remove the three 0.15 inch screws on the underside of the camera.

    • Each of the screws is slightly different, so it is important that you note the original location of each screw.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Find the next two screws on the right side of the camera. One of them is hidden under the USB port cover. The upper screw is .125 inches long, while the lower screw measures .085 inches.

    • Remove both screws, then carefully lift the side panel off.

    • Underneath the side panel, there is a .07 inch screw. Remove it.

    Voeg opmerking toe

    • On the left side of the camera, there are two .085 inch screws. Remove these, then lift the plate from the camera.

    Voeg opmerking toe

    • Now the camera body is loose. gently lift the rear of the case to remove it from the camera.

    Voeg opmerking toe

    • Next, remove the front of the camera body. Be sure to keep track of the rubber ring.

    • You have now successfully removed the outer case.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Matthew Theiss

Lid sinds: 14-04-11

107 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 18-23, Garner Spring 2011 Lid van Cal Poly, Team 18-23, Garner Spring 2011

CPSU-GARNER-S11S18G23

5 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 1,397